Yaskawa J50M Instructions User Manual

Page 234

AND THEIR CONTENTS

(Cent’d)

Note :

specifications effective when #6019

DO= 1.
If #6019 DO = O, rapid traverse is effective
regardless of this parameter specification.

Specifies the delay time for checking the
spindle speed reaching signal (SAG R).

Setting:

Setting range: O to 32767

Specifies the feedrate for the rapid traverse
section in circle cutting (G12, G 13) .

Setting : “ 1“ = 1

or 0.1 inch/rein

Setting range : 0 to 30000

Specifies the maximum feedrate for
designation.

Setting : “ 1“ = 1 mm/min or 0.1 inch/rein

Setting range : 0 to 30000

Note :

The maximum feedrate for

-F4 com-

mands is set in #6226 and that for F5-F9

commands in #6227. Any feedrates increased on
manual pulse generators are bunched into these
settings.

Specifies the

feedrate for the linear axes

(x, Y, z, u, v, w).

Setting : “ 1“ = 1

or 0.1 inch/rein

Setting range : 0 to 30000

Specifies the maximum feedrate for the rotary
axes (A, B, C).

Setting : “ 1“ = 1000 deg/min

Setting range : 0 to 30000

Note:

Any feedrate greater than those set in

#6228 and #6229 are bunched into those settings.

When a circular path is drawn in tool radius
compensation outside a corner approaching

180°, the movement follows on a

small

circular arc.

In this, arc movement is con-

sidered to affect the

surface

machining, this parameter is used to set
the critical arc value.

Setting :

“l” = 0.001

0.001 inch/rein

Setting range : 0 to 32767

The corner arc setting is ignored when:

#6230

Standard setting = 5

Specifies the

speed for rapid traverse

o v e r r i d e .

Setting :

or 0.1 inch/rein

Setting range : 0 to 30000

Specifies the feedrate in the skip function

Setting : “ 1“ = 1 mm/min or 0.1 inch/rein

Setting range : 0 to 30000

Note :

This setting is effective when parameter

= 1.

226