Yaskawa J50M Instructions - Manual (Page 265)

Code
040
041
042
043
. . . . . . . . . .
044
045
----- . . .
046
047
048
Causes
PROG ERROR (M98,
. . . . . . . . . . . .
. P NOT PROGRAMMED IN M98,
G65, G66, G25.
. P DIFFERENT FROM IN
IN G25 MODE,
G25 AND M98/M99 PROGRAMMED
SIMULTANEOUSLY.
PROG ERROR (NO PROG)
PROGRAM NO. (SEQUENCE )
FOUND WHEN PROGRAM IS CALLED BY
M91, M98, M99, G65, G66, G25, G, M, T.
PROG ERROR NEST)
. . . . . . . . --------- -------- ---------- --------- ------
SUBPROGRAM OR MACRO CALL
FIVE-NESTED.
PROG ERROR (G52 Q2)
LOCAL COORDINATE SYSTEM
SPECIFIED WITH WORK COORDINATE
NOT SET.
PROG ERROR
IN CIRCLE CUTTING, PROGRAMMED
RADIUS R IS SMALLER THAN
COMPENSATION D .
CAL ERROR
. . . . . . . . . . . . . . . . . . . . . . .-- —- ------- ----- ----- ----
CALCULATION IMPOSSIBLE DURING
TOOL RADIUS COMPENSATION MODE C .
PROG ERROR
DURING TOOL RADIUS COMPENSATION C
MODE, CIRCULAR ARC OUTSIDE OF
COMPENSATION PLANE PROGRAMMED .
ERROR
. ---------- ----- ------ --------- ------ ----- ------ ----
COMPENSATION PLANE CHANGED
DURING COMPENSATION C MODE.
PROG ERROR
INTERSECTION POINT NOT OBTAINED
BY INTERSECTION COMPUTATION.
Code
049
. . . . . .
050
. . . . . . .
051
052
053
. . . . . . .
054
055
056
. . . . . . --
057
058
. . . . . . . .
Causes
PROG ERROR
REVERSE OR ALMOST REVERSE
COMMANDED IN M97 MODE.
SCALING ERROR
. . . . . .
UNUSABLE G CODE G28 TO
G30, G36 TO G38, G70 TO G72)
IN SCALING MODE.
SCALING ERROR
ERROR IN G51 AND G50 BLOCK
FORMAT .
SCALING FACTOR ZERO.
PROG ERROR (M, S,
. . . . . . . . . . . .. —-. .. --—---- . . . . . . . . . . . . . . . . . . ----
M, S, T, B COMMANDS IN THE
BLOCK IN WHICH M, S,
B
CODE CANNOT BE COMMANDED.
PROG ERROR (AXIS)
AXIS COMMAND IN G04, AND
BLOCKS.
PROG ERROR (S COM)
. . . . . . . . . . ---- . . . . . . . . . .
S EXCEEDS #6274.
DISREGARDED WHEN #6274 = O
MIRROR IMAGE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-- .-—-- --------
COMMANDED DURING MIRROR
IMAGE.