Yaskawa J50M Instructions User Manual

Page 154

4.3.6 DISPLAY IN THE

(SETTING)

FUNCTION

4.3.6.1

D I S P L A Y I N G A N D W R I T I N G S E T T I N G

D A T A

In this system, various setting data are held in the
internal memory and permit to

mirror image

axes, TV check on/off, etc. For details, see Appendix

1, “LIST OF

NUMBERS”.

It is possible to display and write setting data at any

even during automatic operation.

Types of setting

Setting is made in binary mode or decimal

mode.

Binary

mode

Setting numbers #6000 -#6004 are associated
with setting data of binary mode, that is,

8-bit information

(D7-DO) . Each bit in-

dicates the on

state the associated

function.

The decimal value of each line

is given at the rightmost column.

a setting number and then depress the

key. (“#” need not be en-

tered.) Up to 10 groups of setting number and
data will be displayed at a time.

Depress the CURSOR keys to change a set-
ting number and the PAGE keys to change
a screen,

Writing setting data

(1)

(2)

( 3 )

DECIMAL VALUE

Fig. 4.24 Setting (Decimal model) -Example

(4)

Decimal

mode

Setting numbers of #6200 -#6219 and #6500 -

#6599 are associated with setting data of

decimal mode.

( 5 )

binary mode

Designate a desired setting number.

Depress the

key. The cursor

moves to the bit data from a setting num-
ber.

Designate the data of D7.

the

SOR

key.

Each time

the key is

depressed, the cursor moves

one bit toward DO.

Locate the

at a

desired bit position.

Depress the WR key : The designated bit data
reverses (O to 1 or 1 to O). If the WR key is
depressed again, the bit data will reverse
again. Normally, “ 1” designates on state and
“O” off state.

To write data in decimal mode, locate the

at the rightmost column ( decimal

data) .

146