Yaskawa J50M Instructions User Manual

Page 155

EXAMPLE :

Writing in decimal mode

Entered data

—

❑

255

—

(6) Repeat steps (2)

through (5) to write de-

sired data.

If you keep the

key

depressed, the cursor will

move column by column in the screen auto-
matically.

(7) When data has been written, depress the

INSRT key. Normally, this sequence of

begins and ends both with the

depression of the INSRT key.

(1)

(2)

(3)

[n decimal mode

Designate a desired setting number.

Enter a data and depress the WR key. The
data will be assigned to the setting number
which the cursor points to.

Depress the

to change a setting number

PAGE

or the screen.

4.3.6.2 DISPLAY AND WRITING IN THE

DATA INPUT SCREEN*

(a)

the

( b )

( c )

(2)

( a )

Display of the

data

When the

option is provided, display

screen shown in Fig. 4.25 (b) as follows.

Select the

f u n c t i o n k e y .

Depress the

key, and the screen appears.

Writing the F1-digit data

Move the cursor in the

data input

screen to where the data is to be written.

(b) Enter the desired numeral.

k e y .

The entered numeral is

now written.

Fig. 4.25 (b) Example of

Data Input

Display Screen

REMARKS

. System No. setting

(#6219)

Set system No. at

to write

parameter num-

ber.

System number can be set by setting the

value of #6219 through the operator’s panel.

Setting of #6219

“O” : SYSTEM

For normal operation. Writing parameters is pre

v e n t e d .

“ 1“ : PARAMETER

For writing parameters. At this position, cycle start is
prevented.

Setting values other than those described
above will prevent correct operation.

Setting can be effective only when the system

number switch provided on the upper part of
the unit is set at “O. ”

Alarm Display of System No. Setting

When setting #6219 is set at “l” or “4, cycle start is

prohibited or

are over looked, causing

unexpected errors.

To prevent this,

status is displayed if #6219 is set

at a value other than “O”.

147