beautypg.com

Assign chassis address on expansion chassis – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual

Page 69

background image

September 6, 2006

K2 Storage System Instruction Manual

69

Setting up the L2 RAID chassis

cable, which must be connected.

Assign chassis address on Expansion chassis

Every chassis must have a chassis address. The Level two RAID chassis address is
fixed at 0, so no configuration is required. However, if you have a L2 RAID
Expansion chassis you must set its chassis address to 1 as shown in the following
illustration. Also verify that the diagnostic ID switches are in the position shown.

Install Ethernet and diagnostic cabling as shown.

Ethernet Switch

Ethernet cable

L2 RAID Chassis

L2 RAID
Expansion
Chassis
(if installed)

Diagnostic cable

Connect to a
control port

This manual is related to the following products: