beautypg.com

Configuring raid – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual

Page 280

background image

280

K2 Storage System Instruction Manual

September 6, 2006

Chapter 7 Installing the Nearline Storage System

3. Continue with the next procedure to use Storage Utility to configure the file

system.

Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.

Configuring RAID

Use Storage Utility to complete the configuration of the L3 RAID chassis, as
explained in the following topics:

“Verifying controller microcode”

Network Configuration

This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.

NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.

The top port is the port over which the K2 System Configuration
application is communicating with the media server. If correctly
configured, it is already assigned the control network IP address, as
displayed on this page.
Select the other port and click

Modify

. A network configuration dialog

box opens. Enter the FTP/Streaming IP address and the subnet mask and
click

Apply

.

Click

Next

.

File System Server
Configuration

Click

Launch Storage Manager

. Storage Utility opens.

On this page…

Do this…

This manual is related to the following products: