Configuring the gige switch via the web interface – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 102
102
K2 Storage System Instruction Manual
September 6, 2006
Chapter 4 Installing the Level 2R Storage System
to the documentation you received with the switch. Then continue with the next
procedure
“Configuring the GigE switch via the Web interface”
.
• If the version is the currently supported version, continue with the next
procedure.
26.Return to the main menu.
27.Choose
Reboot Switch
to restart the switch.
28.You can now use the switch’s web browser interface for further configuration, as
instructed in the next procedure.
29.Close the PC terminal program and disconnect the console cable.
30.Repeat this procedure on the other switch.
Continue with the next procedure
“Configuring the GigE switch via the Web
interface”
.
Configuring the GigE switch via the Web interface
For redundant systems with two switches, do the following on each switch.
The following steps are for the HP ProCurve switch, which is required for iSCSI
traffic. If you are using a different switch for non-iSCSI traffic, accomplish tasks
similarly on that switch.
1. From the control point PC or another PC, make sure that you have a direct Ethernet
cable connection to the switch, with no switches, routers, proxies, or other
networking devices in between.
2. On the PC, open Internet Explorer and type the switch’s IP address in the Address
field, as in the following example.
http://192.168.100.61
This should be the name or IP address as currently configured on the switch.
3. Press
Enter
to open the switch’s configuration application.
NOTE: The configuration application for the HP ProCurve switch requires Java.
You can also access the switch’s configuration application from the K2 System
Configuration application.
4. In the switch’s configuration application, choose
Configuration
, then
Port
Configuration
.