Assign chassis address on expansion chassis – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 110

110
K2 Storage System Instruction Manual
September 6, 2006
Chapter 4 Installing the Level 2R Storage System
• Each L2 RAID chassis has a single connection to the Ethernet fabric through its
LAN card.
• Each Expansion Adapter on the L2 RAID Expansion chassis requires a
diagnostic cable, which must be connected.
Assign chassis address on Expansion chassis
Every chassis must have a chassis address. The Level two RAID chassis address is
fixed at 0, so no configuration is required. However, if you have a L2 RAID
Expansion chassis you must set its chassis address to 1 as shown in the following
illustration. Also verify that the diagnostic ID switches are in the position shown.
Install Ethernet and diagnostic cabling as shown.
Ethernet Switch
Ethernet cable
L2 RAID Chassis
L2 RAID
Expansion
Chassis
(if installed)
Diagnostic cables
Connect to a
control port