Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 325

September 6, 2006
K2 Storage System Instruction Manual
325
Restoring from the generic recovery disk image on E:
procedure.
14. Select
Database (D:)
and then click
Next
.
The Restored Partition Location page opens.
15. Select
Database (D:)
and then click
Next
.
The Restored Partition Type page opens.
16. Leave the selection at
Primary
and then click
Next
.
The Restored Partition Size page opens.
17. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual D: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next
.
The Next Selection page opens.
18. Select
No, I do not
and then click
Next
.
The Restore Operation option page opens.
19. Do not make any selections. Click
Next
.
The “…ready to proceed…” page opens.
20. Verify that you are restoring the correct partition or partitions. Click
Proceed
.
The Operation Progress page opens and displays progress.
21. When a “The data was successfully restored” message appears, click
OK
.
22. Click
Operations | Exit
to exit the Acronis True Image program.
The K2 Media Server or Level 1 device restarts automatically.
23. Remove any CD currently in the CD drive while the K2 Media Server or Level 1
device is shutting down.
24. Upon restart the Windows Setup Wizard automatically opens. Do Windows setup
as follows:
a. Enter in Windows Product Key and click
Next
.
The Product Key is on a sticker on the top of the machine near the front right
corner.
b. Enter the name of the machine.
For a K2 Media Server name, enter the Serial Number (located at right side and
rear).
For a Level 1 device name, enter the factory default name, which is on a label
near the power button.
The password is pre-set to the factory default. Leave the password as is.
c. Click
Next
d. Set Time and click
Next
.
Windows loads network components and restarts the K2 Media Server or Level 1
device.