Configuring the l1 device - part 2 – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 51

September 6, 2006
K2 Storage System Instruction Manual
51
Configuring the L1 device - Part 2
The configuration file for the media file system is displayed. You can verify media
file system parameters by viewing this file. Do not edit this file. Click
Accept
.
A “…Please wait…” message box displays progress and a “…succeeded…”
message confirms the process is complete.
5. A message informs you that you must restart the Level 1 chassis, however the
restart at the end of the Configure K2 Server wizard suffices, so you do not need to
restart now.
6. Close the Storage Utility.
NOTE: Do not attempt to start K2 Media Clients or otherwise bring the K2 Storage
System online until instructed to do so later in this chapter.
7. Continue with the next procedure.
Configuring the L1 device - Part 2
1. Return to the Configure K2 Server page from which you launched Storage Utility
and proceed as described in the following table:
NOTE: The Level 1 device is represented as a K2 Media Server in the K2 System
Configuration application.