Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 266)

266 K2 Storage System Instruction Manual September 6, 2006
Chapter 7 Installing the Nearline Storage System
Assign Fibre Channel address ID
Every RAID controller must have a unique Fibre Channel address ID that identifies
the controller on the Fibre Channel fabric. On the L3 RAID, you do not need to
manually set the Fibre Channel address ID, as it is pre-set at the factory.
Connect the L3 RAID chassis
Connect Fibre Channel cabling.
L3 RAID
Chassis
All Expansion Chassis connected to DL1
Up to four
Expansion Chassis
are supported
DL1
1st L3 RAID
Expansion
Chassis
Next L3 RAID
Expansion
Chassis
.
.
.
.
.
.
.
.
.
.
Last L3 RAID
Expansion
Chassis
To
1st
media
server
A L3 RAID Chassis with
one controller supports
1 or 2 media servers A L3 RAID Chassis with
two controllers supports
3 or 4 media servers
If the second
controller
is installed,
connect these
cables.
To
2nd
media
server
To
3rd
media
server
To
4th
media
server
DL1