beautypg.com

Adding k2 storage system clients – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual

Page 245

background image

September 6, 2006

K2 Storage System Instruction Manual

245

Adding K2 Storage System clients

3. If you got a “The V: will not be available until this device is rebooted…” message

on the File System Server Configuration page, after the K2 Media Server restarts,
do the following:

a. In the K2 System Configuration application tree view, under the K2 Media

Server select the File System Server node.

The File System Server Configuration page appears.

b. Click

Check

and verify that the V: drive is shared. This is required for NAS

server functionality.

Your configurations for the Level 3R K2 Storage System are complete.

Adding K2 Storage System clients

You can add now clients, such as K2 Media Clients or Aurora Edits, to the K2 Storage
System and configure them using the K2 System Configuration application.

• For Aurora Edits, refer to the Aurora Share Technical Reference Guide for

instructions.

• For K2 Media Clients, refer to K2 Media Client System Guide for instructions.

SCSI Bridge Server
Configuration

This page manages the
components that bridge
between iSCSI (the GigE
media network) and the
RAID storage. You
configure network settings
on the iSCSI adapter and the
page validates that the media
LUNs are visible as iSCSI
targets.

For Level 3 redundant, select

Backup

.

Select an iSCSI adapter and click

Modify

. A network configuration

dialog box opens. Enter the media network IP address and subnet mask
and click

Apply

. Do the same for the other iSCSI adapter.

Click

Next

.

Completing the
Configuration Wizard

Click

Finish

. The wizard closes. The K2 Media Server restarts. Do not

proceed until restart processes are finished. If you are not sure if startup
is complete, wait 10 minutes.

On this page…

Do this…

This manual is related to the following products: