Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 236)

236 K2 Storage System Instruction Manual September 6, 2006
Chapter 6 Installing the Level 3R Storage System
Configuring the redundant media server 1B
You must wait for the primary media server to restart before continuing. To verify,
from the control point PC open the MS-DOS command prompt and use the “ping”
command.
For Level 3 redundant, after you have configured the first media server (server 1A)
you next configure its redundant partner media server (server 1B).
1. In the K2 System Configuration application tree view, select the media server you
are configuring as server IB.
2. Click the Configure button. The Configure K2 Storage System Server wizard
opens. Follow the on-screen text to configure the server for a Level 3R K2 Storage
System, as described in the following table. Some screens require no input from
you, as they are based on the configurations already completed on a previously
configured media server.
Completing the
Configuration Wizard Click Finish . The wizard closes. The K2 Media Server restarts. Wait
until all startup processes have completed before continuing. If you are
not sure if startup is complete, wait 10 minutes.
On this page… Do this…
Define server roles
Enter the name for the media server. This should be the current network
name of the machine.
Enter the name or IP address of the Ethernet switch, as currently
configured on the switch, to which the media server is connected.
For Level 3 redundant, select
SNFS file system server , iSCSI bridge ,
and Media database server .
Click Next
On this page… Do this…