Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 62

62
K2 Storage System Instruction Manual
September 6, 2006
Chapter 3 Installing the Level 2 Storage System
You can also access the switch’s configuration application from the K2 System
Configuration application.
4. In the switch’s configuration application, choose
Configuration
, then
Port
Configuration
.
5. If you do not need trunks, such as on a one-switch system, skip to the next step in
this procedure. If you need trunks, such as on a two-switch system with ISLs, do
the following:
a. Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the
bottom of the list. In the configuration for 10 Gig ISLs, ports 25 and 26 are Trk1.
b. Click
Modify Selected Ports
.
c. For the trunked ports, set Port Enabled to
Yes
. The 10 Gig ISL ports are disabled