beautypg.com

Adding k2 storage system clients – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual

Page 189

background image

September 6, 2006

K2 Storage System Instruction Manual

189

Adding K2 Storage System clients

Your configurations for the Level 3 K2 Storage System are complete.

Adding K2 Storage System clients

You can add now clients, such as K2 Media Clients or Aurora Edits, to the K2 Storage
System and configure them using the K2 System Configuration application.

• For Aurora Edits, refer to the Aurora Share Technical Reference Guide for

File System Client
Configuration

This media server does not
function as a file system
server. It does function as a
file system client, which is
validated from this page.

Click

Check

. When the wizard reports that the configuration check is

successful, click

Next

.

iSCSI Bridge Server
Configuration

This page manages the
components that bridge
between iSCSI (the GigE
media network) and the
RAID storage. You
configure network settings
on the iSCSI adapter and the
page validates that the media
LUNs are visible as iSCSI
targets.

For Level 3, select

Primary

.

Select an iSCSI adapter and click

Modify

. A network configuration

dialog box opens. Enter the media network IP address and subnet mask
and click

Apply

. Do the same for the other iSCSI adapter.

To verify drives, click

Check

then

View Target Drives

. You should see

all your media drives listed.
Click

Next

.

Completing the
Configuration Wizard

Click

Finish

. The wizard closes. The K2 Media Server restarts. Do not

proceed until restart processes are finished. If you are not sure if startup
is complete, wait 10 minutes.

On this page…

Do this…

This manual is related to the following products: