Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 106)

106 K2 Storage System Instruction Manual September 6, 2006
Chapter 4 Installing the Level 2R Storage System
configuration for 10 Gig ISLs, ports 25 and 26 are Trk1)
c. In the Mode drop-down list, select Tagged , then click Apply . This allows default
VLAN traffic (non-iSCSI) to go over the trunk.
15.Click the VLAN Configuration tab.
16.If you have a trunk, verify that for the default VLAN the trunk is displayed in the
Tagged Ports column.
17.If you have two switches, repeat this procedure for the other switch.
18.Close the switch configuration application.
Setting up the K2 media server
Do the following to prepare each K2 media server:
• Install the server in its permanent location. Refer to the rack mount instructions that
you received with the server’s product bundle.
• Provide power to the servers.
• Connect cables as follows:
iSCSI interface
Power
Keyboard/Mouse
GigE
3
2
1 Fibre Channel
VGA monitor
GigE
(FTP) (control)
ports
(GigE media)
port 1
(USB)
Serial port
port 2