beautypg.com

Configuring the level 1 storage system, Prerequisites for initial configuration – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual

Page 44

background image

44

K2 Storage System Instruction Manual

September 6, 2006

Chapter 2 Installing the Level 1 Storage System

Configuring the Level 1 storage system

Use the topics in this section to do the initial configuration of the Level 1 storage
system.

“Prerequisites for initial configuration” on page 44

“Defining a new K2 Storage System” on page 45

“Configuring the L1 device - Part 1” on page 47

“Creating a new file system” on page 49

“Configuring the L1 device - Part 2” on page 51

Prerequisites for initial configuration

Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information. Also refer to

Chapter 8, “Description of K2 Storage Devices”

.

Devices

Prerequisite for Level 1 configuration

Control point PC

Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on

Ethernet switch

Ethernet cables connected
Control network IP address assigned
VLANs set up
Power on

Level 1 chassis

Software installed, as from the factory, including QuickTime 7
Ethernet cable(s) connected
Control network IP address assigned
Power on

This manual is related to the following products: