beautypg.com

Setting up the level 3 gige switch – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual

Page 152

background image

152

K2 Storage System Instruction Manual

September 6, 2006

Chapter 5 Installing the Level 3 Storage System

2. Select Settings tab

3. Select the Advanced button

4. In the General tab, set the DPI setting to Normal size (96 DPI)

5. Restart the PC

Setting up the Level 3 GigE switch

These procedures are for the HP ProCurve switch. You must use the HP ProCurve
switch for iSCSI traffic. However, for control and FTP/streaming traffic, it is allowed
to use a different brand of switch, such as a Cisco Catalyst switch, if required by your
site. If you are using a non-HP switch, apply the information accordingly. Refer to the
documentation you received with the switch as necessary.

Also refer to

“Design considerations for Ethernet switches” on page 376

.

• Use CAT5 or higher cables. The maximum cable length is 50 meters.

• Assign an IP address and logon to the switch. Refer to

“Configuring the GigE

switch via serial connection” on page 153

.

• Set up VLANs on the switch. Refer to

“Configuring the GigE switch via the Web

interface” on page 155

.

• Install the switch in its permanent location.

• Provide power to the switch.

• Connect cables as follows:

To the media ports make one iSCSI connection from each K2 Media Client or other
iSCSI client and two iSCSI connections from each media server.

To the control ports make one connection from each K2 Media Client or other
iSCSI client, from the RAID storage chassis, and from the control point PC. Also
make the FTP network connection and the control network connection from each
K2 media server.

Refer to

“Level 3 system description” on page 150

for a diagram of the complete

system.

Refer to cabling procedures later in this chapter for the GigE connections at each of
the devices of the K2 Storage System.

Also refer to

“K2 Ethernet switch description” on page 299

and

“Design

considerations for Ethernet switches” on page 376

.

Media Ports

Control Ports

1 - 19 odd

2 - 20 even

This manual is related to the following products: