Creating a new file system – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 49

September 6, 2006
K2 Storage System Instruction Manual
49
Creating a new file system
3. Continue with the next procedure to use Storage Utility to configure the file
system.
Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Creating a new file system
Use Storage Utility to create the file system on the L1 device chassis, as explained in
the following topics.
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.
The top port is the port over which the K2 System Configuration
application is communicating with the L1 device. If correctly
configured, it is already assigned the control network IP address, as
displayed on this page.
Select the other port and click
Modify
. A network configuration dialog
box opens. Enter the FTP/Streaming IP address and the subnet mask and
click
Apply
.
Click
Next
.
File System Server
Configuration
Click
Launch Storage Manager
. Storage Utility opens.
On this page…
Do this…