Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 201)

September 6, 2006 K2 Storage System Instruction Manual 201
Setting up the Level 3R redundant GigE switches
field, as in the following example.
http://192.168.100.61
This should be the name or IP address as currently configured on the switch.
3. Press Enter to open the switch’s configuration application.
NOTE: The configuration application for the HP ProCurve switch requires Java.
You can also access the switch’s configuration application from the K2 System
Configuration application.
4. In the switch’s configuration application, choose Configuration , then Port
Configuration .
5. If you do not need trunks, such as on a one-switch system, skip to the next step in
this procedure. If you need trunks, such as on a two-switch system with ISLs, do
the following:
a. Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the
bottom of the list. In the configuration for 10 Gig ISLs, ports 25 and 26 are Trk1.
b. Click Modify Selected Ports .