Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 268)

268 K2 Storage System Instruction Manual September 6, 2006
Chapter 7 Installing the Nearline Storage System
Do not swap Expansion chassis or otherwise reconfigure storage. If you connect a
L3 RAID Expansion chassis to the wrong controller such that the Expansion
chassis contains disk modules that were bound using a different controller you will
lose your media file system.
On each L3 RAID Expansion Chassis
set the same chassis address
on both Expansion adapters.
0
Chassis Address
on RAID Chassis
is pre-set. Do not
attempt to change
this setting.
Chassis
Address = 1
Chassis
Address = 0
Chassis
Address = 0
1
DL1 DL1
L3 RAID
Chassis
Expansion
Chassis 1
Expansion
Chassis 2
Chassis
Address = 2
2
Expansion
Chassis 3
All Expansion Chassis connected to DL1
3
Chassis
Address = 3
Expansion
Chassis 4