Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 198)

198 K2 Storage System Instruction Manual September 6, 2006
Chapter 6 Installing the Level 3R Storage System
Configuring the GigE switch via serial connection
NOTE: Make sure you check the switch firmware and upgrade if necessary, as
instructed at the end of this procedure.
For redundant systems with two switches, do the following on each switch.
Use a direct console connection to the switch, start a console session, and access the
Switch Setup screen to set the IP address. The following procedure is for the HP
ProCurve switch, which is required for iSCSI traffic. If you are using a non-HP switch
for non-iSCSI traffic, accomplish the same tasks as appropriate. Consult the
documentation that came with the switch for more information.
1. Configure the PC terminal emulator on the control point PC or another PC as a
DEC VT-100 (ANSI) terminal or use a VT-100 terminal, and configure either one
to operate with these settings:
• Baud rate 115200
• 8 data bits, 1 stop bit, no parity, and flow control set to Xon/Xoff
• Also disable (uncheck) the “Use Function, Arrow, and Ctrl Keys for Windows”
option
2. Connect the PC to the switch’s Console Port using the console cable included with
the switch. (If your PC or terminal has a 25-pin serial connector, first attach a 9-pin
to 25-pin straight-through adapter at one end of the console cable.)
3. Turn on the PC’s power and start the PC terminal program.
4. Press Enter two or three times and you will see the copyright page and the message
“Press any key to continue”. Press a key, and you will then see the switch console
command (CLI) prompt.
NOTE: If you press Enter too many times and get past the log in, enter the
command EN to get into the command line.
5. Type menu, choose Switch Configuration, then IP Configuration , then Edit . Enter the
switch’s control network IP address. Refer to “Networking tips” on page 50 .
6. Change Gateway to be the default router.
7. Tab to the IP Config (DHCP/Bootp) field and use the Space bar to select the Manual
option.
8. Tab to the Subnet Mask field and enter the subnet mask used for your network.
9. Press Enter , then right-arrow to Save . Press Enter again and revert to previous
menu.
10.Press Enter , then right-arrow to Save . Press Enter again and revert to previous
menu.
11.Return to the main menu.
12.From the main menu, tab to Command Line (CLI) and press Enter . The command
prompt appears.
13.Type configure to change to configuration mode.