Setting up the l1 device chassis – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 35

September 6, 2006
K2 Storage System Instruction Manual
35
Setting up the L1 device chassis
configuration for 10 Gig ISLs, ports 25 and 26 are Trk1)
c. In the Mode drop-down list, select
Tagged
, then click
Apply
. This allows default
VLAN traffic (non-iSCSI) to go over the trunk.
15.Click the
VLAN Configuration
tab.
16.If you have a trunk, verify that for the default VLAN the trunk is displayed in the
Tagged Ports column.
17.If you have two switches, repeat this procedure for the other switch.
18.Close the switch configuration application.
Setting up the L1 device chassis
Do the following to prepare the Level 1 device:
• Install the chassis in its permanent location. Refer to the Level 1 Instruction
Manual for rack mount instructions.
•
“Connect the L1 device chassis” on page 36
•
“Power on the L1 device chassis” on page 37
•
“Configure the Level 1 device network settings” on page 37
Also refer to
“Level 1 K2 Media Server and RAID Storage description” on page 302
.