Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 162)

162 K2 Storage System Instruction Manual September 6, 2006
Chapter 5 Installing the Level 3 Storage System
Assign Fibre Channel address ID
Every RAID controller must have a unique Fibre Channel address ID that identifies
the controller on the Fibre Channel fabric. On the L3 RAID, you do not need to
manually set the Fibre Channel address ID, as it is pre-set at the factory.
Connect the L3 RAID chassis
Connect Ethernet cabling as shown in the following diagram.
Connect Fibre Channel cabling.
L3 RAID
Chassis
Connect Expansion Chassis in order alternating between DL1 and DL0
These Expansion Chassis connected to DL1 These Expansion Chassis connected to DL0
DL0 DL1
2nd L3 RAID
Expansion
Chassis
(if installed)
4th L3 RAID
Expansion
Chassis
(if installed)
6th L3 RAID
Expansion
Chassis
(if installed)
3rd L3 RAID
Expansion
Chassis
(if installed)
1st L3 RAID
Expansion
Chassis
(if installed)
5th L3 RAID
Expansion
Chassis
(if installed)
7th L3 RAID
Expansion
Chassis
(if installed)
To
media
server 1
To
media
server 2