Power on the l1 device chassis, Configure the level 1 device network settings, Setting up the l1 device chassis – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 37

September 6, 2006
K2 Storage System Instruction Manual
37
Setting up the L1 device chassis
Power on the L1 device chassis
Configure the Level 1 device network settings
Use standard Windows procedures to do the following:
Power-up Verification
Power LED - Goes on and stays on
Service LED - Stays off
Refer to the Level 1 Instruction Manual if there is a
problem.
Connect and turn on power as shown.
Release and flip down front bezel.
Connect power cords.
Press standby button.
- 115V/230V -
GV001234
Power LED
Service LED
1
2
3
This manual is related to the following products: