Networking tips, Setting up host tables, Networking tips setting up host tables – Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 272: Chapter 7 installing the nearline storage system

272
K2 Storage System Instruction Manual
September 6, 2006
Chapter 7 Installing the Nearline Storage System
Networking tips
• Before beginning network configuration, determine the IP addresses and names
needed for the machines in your K2 system. Work with the network administrator
at your facility to have those IP addresses and names available for your use.
• Establish a consistent convention for machine names and IP addresses. It is
recommended that you embed a root name or other unique identifier for this
particular K2 Storage System in the computer name. Also, a common convention
for IP addresses is to use a numerical pattern or sequence in the IP addresses to
indicate device-types and/or ports, as in the following example:
NOTE: This example assumes a subnet mask of 255.255.255.0
Example of Nearline storage system names and IP addresses
Setting up host tables
The hosts file is used by the control network and the streaming/FTP network to
determine the IP address of devices on the network when only a the device name
(hostname) is given. The steps that follow describe how to edit the hosts file located
at C:\Windows\system32\drivers\etc\hosts on Windows XP and Windows 2003
Server operating system computers. If you include the names and addresses of all the
devices on the network, then you can copy the same file onto all the other K2 devices
instead of editing the hosts file on each K2 device.
Computer
name
Device type
Streaming network
addresses
Control network
addresses
Comments
root_server_1
Media server
192.168.101.11
a
a.
This IP address must resolve to hostname
root_server_1_he0
192.168.100.11
All servers use
the streaming
network in their
role of FTP server
and the control
network in their
role as media file
system server.
root_server_2
Media server
192.168.101.21
b
b.
This IP address must resolve to hostname
root_server_2_he0
192.168.100.21
root_server_3
Media server
192.168.101.31
c
c.
This IP address must resolve to hostname
root_server_3_he0
192.168.100.31
root_server_4
Media server
192.168.101.41
d
d.
This IP address must resolve to hostname
root_server_4_he0
192.168.100.41
root_raid_1
RAID
—
192.168.100.51
Each RAID
controller is on
the control
network for
monitoring.
root_raid_2
RAID
—
192.168.100.52
root_gige_1
GigE switch
—
192.168.100.61
—
root_cppc_1
Control point
PC
—
192.168.100.81
—