Grass Valley K2 Storage System Instruction Manual v.3.1 User Manual
Page 322
322
K2 Storage System Instruction Manual
September 6, 2006
Chapter 10 Managing K2 software
device is shutting down.
Restoring from a system-specific recovery disk image on E:
The following procedure can be used on a K2 Media Server or Level 1 device that
needs its image restored, if the image was made from that specific machine. If the
image is the generic factory-default image, refer to the next procedure
from the generic recovery disk image on E:”
1. Make sure that media access is stopped and that the K2 Media Server or Level 1
device on which you are working is out of service.
2. If you have not already done so, connect keyboard, monitor, and mouse to the K2
Media Server or Level 1 device.
3. Insert the Recovery CD and restart the machine. If there is a problem restarting,
hold the standby button down for five seconds to force a hard shutdown. Then press
the standby button again to startup.
The machine boots from the disc. The Acronis True Image program loads.
4. At the startup screen, select
True Image Server (Full Version)
.
The Acronis True Image program loads.
The Acronis True Image main window appears.
5. In the Acronis True Image main window, click
Recovery
.
The Restore Data Wizard opens.
6. On the Welcome page, click
Next
.
The Archive Selection page opens.
7. In the tree view expand the node for the E: partition and select the image file, then
click
Next
:
The Verify Archive Before the Restoring page opens.
8. Leave the selection at
No, I don’t want to verify
and then click
Next
.
The Partition or Disk to Restore page opens.
9. Select
System (C:)
and then click
Next
.
The Restored Partition Location page opens.
10. Select
System (C:)
and then click
Next
.
The Restored Partition Type page opens.
11. Leave the selection at
Active
and then click
Next
.
The Restored Partition Size page opens.
12. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual C: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next
.
The Next Selection page opens.
13. Depending on the partitions you are restoring, do one of the following: