Grass Valley K2 Storage System Instruction Manual v.3.1 - Manual (Page 264)

264 K2 Storage System Instruction Manual September 6, 2006
Chapter 7 Installing the Nearline Storage System
• If you do not have trunks, select all ports.
• If you have trunks, select the remaining ports (the ports not trunked).
7. Click Modify Selected Ports .
8. Make sure Port Enabled is set to Yes , leave Mode as default of Auto and set Flow
Control to Disable .
9. Click Apply Settings .
NOTE: If the switch is used for the Nearline system only and there is no K2 media
(real-time iSCSI) traffic on the switch, there is no need to configure VLANs.
10.Close the switch configuration application.
Setting up the K2 media server
Do the following to prepare each K2 media server:
• Provide power to the servers.
Do not connect the iSCSI ports. They are not used for the Nearline storage
system.
Connect the motherboard GigE port 1 and GigE port 2 to control ports on the
GigE switch.
iSCSI interface
Power
Keyboard/Mouse
GigE
3
2
1 Fibre Channel
VGA monitor
GigE
(FTP) (control)
ports
(not used)
port 1
(USB)
Serial port
port 2