NewTek TriCaster Advanced Edition User Guide User Manual
Page 81
Page | 69
GFX 2
o
Output from M/E 1- (4 or 8)
o
Any single Buffer
o
Follow
M/E Preview
M/E Program
Green (FX)
Gold
Blue Red
o
Black
o
Alpha Matte – Output 2 only
Embedded Audio menu – choose which audio is presented on the corresponding SDI, HDMI, Stream and
Network outputs (Analog Outputs 1 and 2 connections always carry Master and Aux sound, respectively):
o
Outputs
Master 1, 2 (sound from the Master 1 and 2 busses)
Aux 1, 2 (sound from the Aux 1 and 2 busses)
(See Section 15.7.2 for discussion of TriCaster’s internal audio busses).
o
Inputs 1-(4 or 8) – sound from any single audio input
Resolution menu – Output 1 is always at session resolution. For other outputs, select the video format for
downstream devices you intend to connect to the corresponding output:
o
1080i or 1080p – depending on the session format
o
1080i
o
720p
o
480i (4:3) – interlaced NTSC sessions
o
480i (16:9) – interlaced NTSC sessions
o
480p – progressive sessions
o
576i (4:3) – interlaced PAL sessions, Multi-format TriCasters only
o
576i (16:9) – interlaced PAL sessions, Multi-format TriCasters only
o
576p – progressive PAL sessions, Multi-format TriCasters only
Note: Output 1 always transmits video in session format, thus shows Resolution display rather than a menu.
Analog Out menu (not present on TriCaster 410 or TriCaster Mini) – select the video connection type
for downstream devices you intend to connect to the corresponding output:
o
Component
o
Composite + Y/C
Note: The only analog connection type suitable for HD video is Component. The Analog Out menu for primary
outputs are automatically set to Component when the selected Resolution is HD.
Choosing Component or Composite + Y/C results in the output connectors in the corresponding row
being configured as shown in the following table: