NewTek TriCaster Advanced Edition User Guide - Manual (Page 205)

Page | 193
Ping is a command line program, and must be run from a command shell on the issuing computer. To open a
command shell and send a ping, follow the procedure below that applies.
Windows®
1. Repeat the steps you performed above to re-open a command shell.
2. Type “ping” (without quotes) followed by a space and the target IP number, as in the image below –
then press Enter.
FIGURE 234
3. Ping will go to work, and in a moment or two begin reporting results. A ping failure (indicating a
network problem) will look like Figure 235. A success ping will display a report like Figure 236.
FIGURE 235
FIGURE 236