Lf - load fuel authorizations – Gasboy 1000 Series FMS Operation Manual User Manual
Page 96

GASBOY Series 1000
10-2
05/29/03
LF - LOAD FUEL AUTHORIZATIONS
Use the LF command to assign fuel types to the product authorization codes. There are ten
product authorization codes (0 to 9). Code zero is preset to allow all fuel types. You load codes 1
through 9 with up to five fuel types per code.
When you encode the cards for your system, you decide which fuel types will go with which
authorization code. You load these fuel types into the system when you use the LP command.
Then you encode the authorization code (0 to 9) onto each user’s card. They can access only the
fuel types assigned to that code.
1. At
the
*
prompt, type LF. The system displays AUTH NO.:
2.
Type an authorization code number from 1 to 9 and press RETURN. The system displays
ALLOW: followed by the first of the five present fuel codes.
3.
To add a new fuel code, type the 2-digit code and press RETURN. These 2-digit codes must
match the ones you entered in the LP (load pump data) command.
To keep the existing fuel code value, press RETURN.
The next currently assigned fuel code is listed.
NOTE:
If you do not wish to enter additional fuel codes, type 0 (zero) at the ALLOW:
prompt and press RETURN. This displays the next AUTH NO.: prompt. Skip to
Step 5.
4.
Repeat Step 3 to change or retain the next fuel code.
5.
When all desired fuel assignments are loaded, the AUTH NO.: prompt reappears. Repeat
this procedure from Step 2 to define fuel types for additional authorization codes.
To stop entering authorization codes, press RETURN at the AUTH NO.: prompt. The
*
prompt reappears.
Example:
HBÂ
Â
7WVDÂPQÂ0Â#
↵
Â
7HHQY0Â #Â"&
↵
Â
7HHQY0Â Â!#
↵
Â
7HHQY0Â "
↵
Â
7HHQY0Â!&
↵
Â
7HHQY0Â Â !
↵
Â
Â
7WVDÂPQÂ0Â$
↵
Â
7HHQY0Â !
↵
Â
7HHQY0Â Â
↵
Â
Â
7WVDÂPQÂ0
↵
Â
Â
Â