beautypg.com

Lv - load a vehicle record – Gasboy 1000 Series FMS Operation Manual User Manual

Page 184

background image

GASBOY Series 1000

22-4

05/29/03

LV - LOAD A VEHICLE RECORD


Use the LV command to enter a new vehicle record (vehicle number and odometer/hours reading)
into the system. If you wish to enter just odometer/hours readings for an existing vehicle, use the
LO command.

NOTE:

The prompts and procedure steps shown in this section are for reasonable odometer.
If you have the reasonable hours option, your prompts will contain HOURS instead of
ODOM (odometer). An example of reasonable hours commands is shown at the end
of this command procedure.


1. At

the

*

prompt, type LV. The system displays: VEH. NO.


2. Type up to a 6-digit vehicle number and press RETURN. The system displays: BEGIN

ODOM:


NOTE: If the vehicle record already exists, the system displays RECORD EXISTS

ALREADY! The VEH. NO. prompt reappears.


3.

Type the vehicle’s present odometer reading (up to six digits) and press RETURN. The VEH.
NO.
prompt reappears.


4.

To define additional vehicles and odometer readings, repeat this procedure from Step 2.


To stop entering vehicle information, press RETURN at the VEH. NO. prompt. The

*

prompt

reappears.


Example - Reasonable Odometer:

Â
HXÂ
Â
XADÂPQÂ %$#

Â

8ACEPÂQ@QI0ÂÂ"(%

Â

Â
XADÂPQ

Â

Â
Â



Example - Reasonable Hours:

Â
HXÂ
Â
XADÂPQÂ$#"!

Â

8ACEPÂDQWTU0ÂÂ "%&

Â

Â
XADÂPQ

Â

Â
Â