Gasboy 1000 Series FMS Operation Manual - Manual (Page 203)

Supervisor Card Option
05/29/03 24-3
FUELING WITH A SUPERVISOR CARD
To fuel with a supervisor card:
1. At
the ENTER CARD prompt, insert the supervisor card into the card reader. The LCD
displays: REMOVE CARD
2.
Remove the card from the reader. If you are using a one card system, or an optical card
system, the system prompts you to enter the required card data. Proceed to Step 6.
3.
If you are using a two-card system, the LCD displays: ENTER SECOND CARD
4.
Insert your second card into the reader. The LCD displays: REMOVE CARD
5. Remove the card from the reader. The LCD prompts you to enter the required card data
fields.
6.
Enter the appropriate data. Complete each entry by pressing ENTER.
Example: If you are using a mag card that has AAAA encoded in the CARD NUMBER
field, EEEE in the EMPLOYEE NUMBER field, and AAAA encoded in the
VEHICLE NUMBER field, the prompts appear in the following sequence:
ENTER CARD #
ENTER EMP
ENTER VEH
7.
After you enter the appropriate card data, proceed with the fueling sequence as described in
Section 2 (Fueling with the Series 1000) beginning at Step 7.