Le - load ending odometer/hours – Gasboy 1000 Series FMS Operation Manual User Manual
Page 161

L/100KM or LPH Option
05/29/03
19-13
LE - LOAD ENDING ODOMETER/HOURS
Use the LE command to load an ending odometer or hours reading. This is useful if a vehicle was
fueled off-site or an invalid odometer/hours entry was made.
NOTE: The prompts and procedure steps shown are for L/100KM. If you have the liters-per-hour
option, your prompts will contain HOURS instead of ODOM. An example of LPH
commands is shown at the end of this command procedure.
1. At
the
*
prompt, type LE. The system displays: VEH. NO.
2.
Type the vehicle number and press RETURN. The system displays: ENDING ODOM:
NOTE: If the vehicle record does not exist, the system displays NO RECORD FOUND!
The VEH. NO. prompt reappears.
3.
Type the current ending odometer and press RETURN. The VEH. NO. prompt reappears.
NOTE:
The ending odometer reading must be greater than the beginning odometer
reading or system displays the message INVALID ENDING ODOM! The VEH.
NO. prompt reappears.
4.
To type additional odometer readings, repeat this procedure from Step 2.
To stop entering odometer readings, press RETURN at the VEH. NO. prompt.
The
*
prompt reappears.
Example for L/100KM:
HAÂ
Â
XADÂPQÂ %$#
↵
Â
AP@EPCÂQ@QI0ÂÂ#%&
↵
Â
Â
XADÂPQÂ
↵
*
Example for LPH:
HAÂ
Â
XADÂPQÂ %$#
↵
Â
AP@EPCÂDQWTU0ÂÂ%
↵
Â
Â
XADÂPQÂ
↵
*