Gasboy 1000 Series FMS Operation Manual - Manual (Page 164)

GASBOY Series 1000
19-16 05/29/03
DC - DISABLE L/100KM CALCULATION AND
REASONABLE ODOMETER CHECK FOR ALL VEHICLES
Use the DC command to disable L/100KM or LPH calculation and reasonable odometer/hours
check for all vehicle records contained in the vehicle file. Total liter and odometer/hours data will
continue to be updated for all vehicle records contained in the vehicle file, but the system will not
calculate L/100KM or LPH or execute reasonable odometer/hours checks on these vehicles.
NOTE: The prompts and procedure steps shown are for L/100KM. If you have the liters-per-hour
option, your prompts will contain LPH instead of L/100. An example of LPH commands is
shown at the end of this command procedure.
1. At
the * prompt, type DC. The system displays:
DISABLE L/100KM CALCULATION FOR ALL VEHICLES?
2. Type
Y and press RETURN to disable the L/100KM calculation and reasonable odometer
check option for all vehicle records currently in the vehicle file. Type N and press RETURN
to leave the vehicle file as is.
NOTE: Only Y or N are valid responses; if you type anything else, the system re-prompts you
until you enter a Y or N.
The
* prompt reappears.
Example for L/100KM:
@9Â
@EU78HAÂH! GIÂ97H9WH7VEQPÂBQTÂ7HHÂXADE9HAU5Â2aÂQTÂP4Âa ↵ Â
Â
Example for LPH:
@9Â
@EU78HAÂHRDÂ97H9WH7VEQPÂBQTÂ7HHÂXADE9HAU5Â2aÂQTÂP4Âa ↵ Â
Â