Gasboy 1000 Series FMS Operation Manual - Manual (Page 214)

GASBOY Series 1000
27-2 05/29/03
SWITCHES AND SETTINGS
Printer Status Board
The printer status board (Figure 27-2) is attached to the
inside of the printer access door (See Figure 27-1) This
location provides the site attendant easy access to the
switches and indicator lamps needed to perform paper
loading, self-tests, and simple troubleshooting.
Figure 27-2. Printer Status Board
Status Board Switches
Table 27-1 summarizes switches and results for the printer status board.
Table 27-1. Status Board Switches
SW1 POWER
Switching SW1 to the left turns power on to the printer and the status board.
Switching SW1 to the right removes power from the printer and status board
SW2 SELF-TEST
Switching SW2 to the left starts a self-test of the printer. It will print a barber-pole
pattern of all the characters that may be printed on a receipt.
Switching SW2 to the right stops the printing and cuts the paper.
A short self-test should be performed whenever the paper or ribbon is changed.
SW3 PAPER FEED
Pressing SW3 causes a continuous paper feed. This is used while loading new paper.
SW4 ON LINE
Pushing this switch alternately puts the printer in the online or offline mode. The printer
must always be online (green lamp on) to print receipts or do a self-test.