Fuel allocation option – Gasboy 1000 Series FMS Operation Manual User Manual
Page 113

05/29/03
14-1
Section 14
FUEL ALLOCATION OPTION
DESCRIPTION
The Fuel Allocation option allows you to allocate, over a period of time, predetermined amounts of
fuel to users. This option works effectively only in a single site operation. As fuel is withdrawn
from the system, the appropriate allocation totalizer is decremented. When the totalizer reaches
zero, the user is denied fuel until you load a new allocation amount.
If you ordered this option, you indicated the field (Card, ID Field 1 or ID Field 2) to be assigned
the allocation totalizers and the number of totalizers. Then you must assign an allocation offset
(starting number) for the totalizers. For example, if you choose the vehicle number field, have 500
totalizers, and specify 1250 in the AO command, the totalizers are assigned to vehicle numbers
1250 through 1749.
You can add to, or subtract from, individual totalizers or ranges of totalizers at one time. An
allocation table, showing the allocation numbers and their current totalizer values, may be printed
on demand. A total of all totalizer values is also provided.
Allocation Commands
The Fuel Allocation commands are:
●
AO
load a starting point for allocations (allocation offset)
●
LA
load single allocation value
●
ML
load allocations for multiple users
●
AA
add to single allocation
●
MA
add to allocation for multiple users
●
SA
subtract from single allocation
●
MS
subtract from allocation for multiple users
●
CA
check single allocation
●
AT
configure to print all totalizers
●
NZ
configure to print non-zero totalizers
●
PA
print allocation table
●
MP
print range of allocation