Gasboy 1000 Series FMS Operation Manual User Manual
Page 76

GASBOY Series 1000
8-10
05/29/03
IP - INACTIVATE A PUMP
Use the IP command to turn off any pump currently in use, from a data terminal. The pump is
inactivated for that transaction only and the message TTY CMD appears in the error field for that
transaction.
1. At
the
*
prompt, type IP. The system displays PUMP NO.
2.
Type the pump number to inactivate and press RETURN. The
*
prompt reappears.
NOTE:
If you attempt to inactivate a pump which is not in use, the system responds
PUMP NOT ON!
Example:
Â
ERÂ
Â
RWIRÂPQÂ!
↵
Â
Â
Â
Example:
Â
UEVAÂ!"#$Â
Â
VT7PÂ97T@ÂAIRÂÂXADÂÂ@7VAÂÂÂÂÂVEIAÂÂRÆÂRTÂSW7PVEVaÂÂQ@QIÂÂÂATTQTÂ
"! %$#Â"(!#Â'%)& " %"!Â!%0$" ! !ÂÂÂÂ!# %$'(&ÂVVaÂ9I@Â
Â
If the pump was activated with the AP command and then turned off with the IP command, the
message TERM ACTIVATE overrides TTY CMD.