Gasboy 1000 Series FMS Operation Manual - Manual (Page 216)

GASBOY Series 1000
27-4 05/29/03
ACCESSING THE PRINTER FOR MAINTENANCE OR SERVICE
Before beginning any of the following maintenance procedures, you must pull the printer out to a
serviceable position. Follow these steps:
1.
Open the printer access door and loosen the hex head screw.
2.
Pivot the printer assembly to the right in order to clear the paper chute.
3.
Pull the entire printer slide assembly toward you.
4.
Perform any required maintenance or service. Reverse this procedure to return the printer to
normal operation.
CHANGING THE PAPER
Removing the Paper
1.
Follow the procedure for accessing the printer.
2.
Cut the paper where it comes off of the roll.
3.
Press the PAPER FEED switch on the printer status board until all of the paper is removed
from the printer mechanism.
4.
Remove the paper roll, being careful not to bend the PAPER LOW switch.
Figure 27-4. Printer Side View