Gasboy 1000 Series FMS Operation Manual - Manual (Page 157)

L/100KM or LPH Option
05/29/03 19-9
IV - INITIALIZE VEHICLE FILE
Use the IV command to initialize the vehicle file. Use this command only at initial start-up or at
the beginning of a new month or L/100KM or LPH calculation period you set. This
command resets the entire vehicle file; data cannot be retrieved. When this command is
executed, the ending odometer entry becomes the beginning entry and liter totals are reset to
zero.
1. At
the * prompt, type IV. The system displays:
INIT VEHICLE FILE?
2. Type
Y and press RETURN to initialize (reset) the vehicle file. Type N and press RETURN to
leave the vehicle file as is.
NOTE: Only Y or N are valid responses; if you type anything else, the system re-prompts
you until you enter a Y or N.
The
* prompt reappears.
Example:
Â
EXÂ
Â
EPEVÂXADE9HAÂBEHA5Â2aÂQTÂP4Âa
↵ Â
Â
Â