Gasboy 1000 Series FMS Operation Manual - Manual (Page 206)

GASBOY Series 1000
25-2 05/29/03
TM - TANK MONITOR LINK COMMAND
Use the TM command to establish a communications link for the tank monitoring system.
1. At
the * prompt, type TM. The system displays: TANK MONITOR LINK?
2.
To establish the communications link, type Y and press RETURN.
To terminate the request, type N and press RETURN.
If the Series 1000 is successful in establishing a communications link with the tank
monitoring system, it displays this character: >.
Example:
VIÂ
Â
V7PGÂIQPEVQTÂHEPG5Â2aÂQTÂP4Âa ↵ Â
4Â
Â
3.
What happens next depends on the protocol of the tank monitoring system you are using.
The following example is for a Veeder-Root TLS-250. To request a report on this system,
press CTRL A to send an SOH, then type the desired report code and tank number. In our
example, we used 2A1. This prints an alarm status report (code 2A) for tank 1.
VIÂ
Â
V7PGÂIQPEVQTÂHEPG5Â2aÂQTÂP4ÂaÂ
4Â
R†s‡‡Â9VTHÂ7Âvs†sÂ
"7!Â
7H7TIÂUV7VWUÂ
Â
BA8Â"'Â!))"Â
Â)0#(Â7IÂ
ÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂDECDÂÂÂÂQXATÂÂÂHQYÂ
V7PGÂÂRTQ@W9VÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂHA7GÂÂÂY7VATÂÂÂÂBEHHÂÂHEIEVÂÂÂÂVDABVÂ
Â
ÂÂ!ÂÂÂUWRATÂWPHA7@A@ÂÂÂÂÂÂÂÂÂQBBÂÂÂÂÂQBBÂÂÂÂÂQBBÂÂÂÂQBBÂÂÂÂÂÂQBBÂ
Â
A`VATP7HÂEPRWVÂUV7VWU0ÂQRAPÂ
NOTE: See the documentation supplied with your tank monitoring system for additional
communications commands and report codes.