Gasboy 1000 Series FMS Operation Manual - Manual (Page 77)

Pump Commands
05/29/03 8-11
ZP - ZERO PUMP TOTALIZERS
Use the ZP command to reset the pump totalizers to zero. The pump totalizers on the Series
1000 are incrementing totalizers. They can be set back to zero using this command or set
individually to match the corresponding pump totalizer (using the AMOUNT prompt in the LP
command).
1. At
the * prompt, type ZP. The system displays RESET PUMP TOTALIZERS?
2. Type
Y and press RETURN to reset the totalizers to zero. Type N and press RETURN to
leave the totalizers as is.
NOTE: Only Y or N are valid responses; if you type anything else, the system re-prompts
you until you enter a Y or N.
The
* prompt reappears.
Example:
Â
bRÂ
Â
TAUAVÂRWIRÂVQV7HEbATU5Â2aÂQTÂP4Âa
↵ Â
Â
Â