Gasboy 1000 Series FMS Operation Manual - Manual (Page 215)

Receipt Printer Maintenance
05/29/03 27-3
Status Board Lamps
Table 27-2. Status Board Lamps
D1 +12 VOLTS
This lamp should be lit whenever SW1 (Power) is on.
D2 ON LINE
This lamp must be on to print receipts or do a self-test. If it is not on, momentarily press
SW4.
NOTE: This lamp does not have to be lit to feed paper (SW3).
D3 ALARM
This lamp will light when a mechanical failure occurs, or when the printer runs out of
paper.
Controller Board DIP Switch Settings
The controller board DIP switches are set at the
factory prior to shipment. For proper operation of
the printer, set the controller board switch settings
as shown in Table 27-3.
Table 27-3. DIP Switch Settings
DIP SW1 DIP SW2
1-1 ON 2-1 ON
1-2 ON 2-2 ON
1-3 ON 2-3 ON
1-4 ON 2-4 OFF
1-5 OFF
1-6 ON
1-7 ON
1-8 OFF
NOTE: DIP switches are only read by the
controller at power up. DIP switch
changes should be made with the power
off.
Figure 27-3. DIP Switches