Gasboy 1000 Series FMS Operation Manual - Manual (Page 35)

System Maintenance Commands
05/29/03 5-3
● Number of lines per page
If you are using a Link MC5 terminal with an Okidata 184 printer attached, you must specify
the number of lines to be printed on each page (usually 62). If you are not using the terminal
and printer, set the lines per page to 0 (zero).
● Card expiration date
For mag card systems only. Cards can be encoded with an expiration date (year and month).
Once the date is reached, the user is denied further access and a CARD EXPIRED message
appears on the LCD display. This parameter allows you to disable the feature (cards will not
be denied access).
● Auto PIN lockout
When enabled, this feature locks out (invalidates) the card from system access after three
consecutive unsuccessful PIN entries. You must validate the card for it to be active again.
When this feature is disabled, you still get three tries to enter a correct PIN, but the ENTER
CARD message reappears and the card is not invalidated.
● Auto site shut down
This parameter allows you to enable or disable the automatic site shut down time indicated in
the SD command. When this feature is enabled, the site shuts down at the entered time and
a SITE IS DOWN message appears on the LCD display. You can still access other software
features and can activate a pump for one transaction through the AP command. When this
feature is disabled, shutdown does not occur.
You may receive other system configuration prompts depending on the options you have on your
system. These differences are noted in the section describing the option.