Gasboy 1000 Series FMS Operation Manual - Manual (Page 17)

Introduction
4019 1-5
DOCUMENTATION/GETTING STARTED
The following documentation is provided with the Series 1000 Fuel Management System:
● Installation Manual, C08922
● Card Encoding Manual, C08924
● Card Encoding Manual for Commercial Fueling Networks, C08370
● Operation Manual, C08923
● Diagnostic Manual, C08925
In addition, your authorized service representative (ASR) is provided with the following manual:
● Start-up Manual, C08921
When you get to this point, we assume:
● your system has been installed and tested (Reference: Installation Manual).
● your ASR has started up your system, and helped you perform necessary tests (Reference:
Start-up Manual).
● your ASR has helped you with your initial configuration (Reference: Start-up Manual and
Operation Manual)
When you configure your system you need to know:
- number of pumps (outlets)
- number of tanks
- pulser type
- pulses per liter or dollar (penny pulsing)
- fuels and fuel codes
- fuel code authorizations and limitations
- communications port settings
- site shutdown start and end times
- the type of lockout file you wish to create
Your ASR will help you perform these commands:
SC configure your system
MO allows you to view data one screen at a time on your CRT (if desired)
RT initialize transaction file
LN load starting transaction number
LD load system date and time
LK load 4-digit PIN key (assigned on card layout)
SD load shutdown start and end times
LI load initial inventory for each tank
LR load an inventory reorder point for each tank
LP assign specific fuels, tanks, totalizer readings, and timeouts to your pumps
LL assign maximum fuel quantities to limitation codes
LF assign fuel codes to authorization codes
VA or IA validate or invalidate all cards depending on the type of card file you’ve chosen
(negative or positive)
● Your cards should be encoded (Reference: Card Encoding Manual or Card Encoding Manual
for Commercial Fueling Networks, C08370).