Gasboy 1000 Series FMS Operation Manual - Manual (Page 158)

GASBOY Series 1000
19-10 05/29/03
VF - PRINT VEHICLE FILE
Use the VF command to print the contents of the vehicle file. The vehicle file is different for
L/100KM and LPH. Both are shown below.
1. At
the * prompt, type VF. The listing prints.
For L/100KM, this listing includes: the maximum kilometers between fuelings, the vehicle number,
beginning and ending odometer, total kilometers driven, total liters used, the L/100KM calculation
(for vehicles with the option enabled), and a status message.
Example for L/100KM:
XBÂ
 I7`ÂGHIUÂ8AVYAAPÂ
 BWAHEPCU % Â
Â
XADÂÂ8ÂQ@QIÂAÂQ@QIÂGHIUÂÂÂÂÂÂHEVATUÂÂH! Â UV7VÂ
%$#Â #!"%&Â #!%%$Â ")(ÂÂÂÂ!& ÂÂÂÂ%$Â
!#$"Â $#%'(Â $#)%'Â #')ÂÂÂÂÂ'! ÂÂÂÂ!)Â HQYÂ
$" Â ! Â "% Â !% ÂÂÂÂ"(! ÂÂÂ%"'Â 22Â
%!)&Â Â "'#%Â "'#%ÂÂÂÂÂ ÂÂÂÂ Â Â
Â
Â
Â
NOTE: The letters N/A will be displayed in the L/100 field if the L/100KM calculation and
reasonable odometer check option has been disabled for this vehicle.
The status messages appear in the last column of the report. Status messages and their
meanings are:
HIGH
The L/100KM calculation was above 50
LOW
The L/100KM calculation was below 5
<<
The last odometer entry was less than the beginning odometer and could not be
recorded. Fueling was allowed.
%%
The record has an initial value; no transactions occurred since it was initialized.
**
The ending odometer reading was entered via the data terminal
For LPH, this listing includes: the maximum hours between fuelings, the vehicle number,
beginning and ending hours, accumulated hours, liters used, the LPH calculation (for
vehicles/equipment with the option enabled), and a status message.