Gasboy 1000 Series FMS Operation Manual - Manual (Page 186)

GASBOY Series 1000
22-6 05/29/03
LO - LOAD ODOMETER/HOURS
Use the LO command to update odometer/hours readings for an existing vehicle record. This
command helps to maintain accurate odometer/hours readings (such as in cases where the
selected vehicle may have fueled at another location, etc.)
NOTE:
The prompts and procedure steps shown in this section are for reasonable odometer.
If you have the reasonable hours option, your prompts will contain HOURS instead of
ODOM (odometer). An example of reasonable hours commands is shown at the end
of this command procedure.
1. At
the * prompt, type LO. The system displays: VEH. NO.
2.
Type the vehicle number and press RETURN. The system displays: BEGIN ODOM:
NOTE: If the vehicle record does not exist, the system displays NO RECORD FOUND!
The VEH. NO. prompt reappears.
3.
Type the vehicle’s present odometer reading and press RETURN.
4.
To update additional odometer readings, repeat this procedure from Step 2.
To stop updating odometer readings, press RETURN at the VEH. NO. prompt.
The
* prompt reappears.
Example for reasonable odometer:
HQÂ
Â
XADÂPQÂ %$#
↵ Â
8ACEPÂQ@QI0Â$%( ↵ Â
Â
XADÂPQÂ
↵ Â
Â
Example for reasonable hours:
HQÂ
Â
XADÂPQÂ$#"!
↵ Â
8ACEPÂDQWTU0Â "%& ↵ Â
Â
XADÂPQÂ
↵ Â
Â