Gasboy 1000 Series FMS Operation Manual - Manual (Page 163)

L/100KM or LPH Option
05/29/03 19-15
EC - ENABLE L/100KM (OR LPH) CALCULATION AND
REASONABLE ODOMETER/HOURS CHECK FOR ALL VEHICLES
Use the EC command to enable L/100KM or LPH calculation and reasonable odometer/hours
check for all vehicle records contained in the vehicle file. This command resets the entire vehicle
file; data cannot be retrieved. When this command is executed, the ending odometer/hours entry
becomes the beginning entry and liter totals are reset to zero.
NOTE: The prompts and procedure steps shown are for L/100KM. If you have the liters-per-hour
option, your prompts will contain LPH instead of L/100. An example of LPH commands is
shown at the end of this command procedure.
1. At
the * prompt, type EC. The system displays:
ENABLE L/100KM CALCULATION FOR ALL VEHICLES?
2. Type
Y and press RETURN to enable the L/100KM calculation and reasonable odometer
check option for all vehicle records currently in the vehicle file. Type N and press RETURN
to leave the vehicle file as is.
NOTE:
Only Y or N are valid responses; if you type anything else, the system re-prompts
you until you enter a Y or N.
The
* prompt reappears.
Example for L/100KM:
A9Â
AP78HAÂH! GIÂ97H9WH7VEQPÂBQTÂ7HHÂXADE9HAU5Â2aÂQTÂP4Âa ↵ Â
Â
Example for LPH:
A9Â
AP78HAÂHRDÂ97H9WH7VEQPÂBQTÂ7HHÂXADE9HAU5Â2aÂQTÂP4Âa ↵ Â
Â