2 odu | config (kst-2000a/b) – Comtech EF Data CDM-570A User Manual
Page 404
CDM-570A/570AL Satellite Modem with Optional Packet Processor
MN-CDM570A
CDM-570A/570AL ODU (Transceiver, BUC, LNB) Operation
Revision 2
10–30
10.2.2.1.2.2 ODU | Config (KST-2000A/B)
Figure 10-8 shows the ‘ODU | Config’ page with the KST-2000A/B configured as the ODU. Use
this page to configure the primary KST-2000A/B Transmit and Receive Parameters.
Figure 10-8. ODU | Config page (KST-2000A/B)
Upconverter Parameters
•
Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
•
Output – Select On or Off from the drop-down list.
Downconverter Parameters
•
Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
•
Rx Band (For KST-2000B Only): Select band A (10950 to 11700 MHz), band B (11700 to
12200 MHz), or band C (12250 to 12750 MHz) from the drop-down list
HPA Parameters
•
HPA Power Enable – Select On or Off from the drop-down list.
•
HPA Fault Logic – Select Summary or No Summary from the drop-down list.
LNA Parameters
•
LNA Power Enable – Select On or Off from the drop-down list.
•
LNA Fault Logic – Select Summary or No Summary from the drop-down list.