beautypg.com

Comtech EF Data CDM-570A User Manual

Page 310

background image

CDM-570A/570AL Satellite Modem with Optional Packet Processor

MN-CDM570A

Optional Packet Processor - Serial/Telnet CLI Operation

Revision 2

9–14

Selection

Hot Key Description

IGMP

I

Use the IGMP protocol to regulate Multicast traffic on a LAN segment to

prevent information of no interest from consuming bandwidth on the LAN.

Toggle [Enabled] or [Disabled]:

When Enabled, the Packet Processor reports an interest to join a

Multicast group on an IGMP server:

o The receive portion of the Packet Processor is utilized as an

IGMP server.

o The transmit portion of the Packet Processor is utilized as an

IGMP client.

Downlink Route All Available

Multicast

M

Toggle [Enabled] or [Disabled]:

When Enabled, the Packet Processor routes all Multicast packets

coming from the Satellite interface to the Ethernet LAN regardless of

the Route Table entries.

When Disabled, the Packet Processor does not automatically forward

all Multicast packets. The Packet Processor will forward Multicast

traffic received from the satellite to the Ethernet port only if the

Multicast route exists in the Route Table.

Quality of Service (QoS)

Q

This FAST feature must be purchased.

Toggle [Enabled] or [Disabled]:

When Enabled, the Packet Processor applies configured QoS rules

on all packets going out the Satellite Interface.

When Disabled, the Packet Processor does not apply QoS rules for

outgoing packets.

Transmit 3xDES Encryption

N/A

3xDES Encryption is a future offering and is not

available in this firmware release. These

selections are therefore non-functioning at this

time.

Receive 3XDES Decryption

L3/L4/L5 Tx Header

Compression

H

This option compresses L3/L4/L5 headers. Headers available for

compression can be referenced in the IP Header Compression section.

Note that:

In Managed Switch mode, all L2 Ethernet Headers are compressed

whether or not this feature is Enabled.

In Router mode, this screen shows compression as Available, and the

option must be Enabled per route using the Route Table page.

This manual is related to the following products: